Router Settings
If you are using your own modem with your Compass internet connection, you will need to configure it with the settings below.
Fibre
WAN Connection Type: PPPoE
Username: customer@compassnet.co.nz
Password: compass
Vlan Tagging - Disabled IP Version: IPv4 or IPv6
MTU Size: 1492 or 1500 NAT: Enabled
ADSL
Username: customer@compassnet.co.nz
Password: compass
Connection Type: PPPoA
Encapsulation: VC-MUX
VPI: 0
VCI: 100
MTU: 1492 or 1500
VDSL
WAN Connection Type: PPPoE
Username: customer@compassnet.co.nz
Password: compass
Connection Type: VDSL or VDSL 2
Interface: PTM 0
VLAN ID: 10
MTU: 1492 or 1500
These will work on most modem/routers as long as the modem is not carrier locked and you have configured it correctly. The settings will also vary depending on the type of connection you have; such as ADSL, VDSL, or UFB.
| UFB | ADSL | VDSL | |
| WAN Type | Ethernet WAN | ADSL | VDSL |
| Interface | ETH | ATM | PTM |
| VPI |
| 0 |
|
| VCI |
| 100 |
|
| Connection Type | PPPoE | PPPoA | PPPoE |
| VLAN ID | Disabled | Disabled | 10 |
| PPP Username | |||
| PPP Password | compass | compass | compass |
| MTU | 1492 | 1492 | 1492 |
| IP Address | Obtain Automatically | Obtain Automatically | Obtain Automatically |
If you are using a router that you received from Compass please click through to the following links to access the router specific reconfigure guides for these routers: